These dimensions are for standard Locost suspension with the axle centre line moved to calculate bump steer.

600	Wheel diameter - for this application the diameter is not important

The track rod end is 63.3mm below the centre line of the axle so move the axle centre line down by 63.3mm
to calculate bump steer

115	distance from top balljoint to centre line of tyre
177.3	distance from top balljoint to centre line of track rod end  114 + 63.3=177.3
95	distance from bottom balljoint to centre line of tyre
46.7	distance from bottom balljoint to centre line of track rod end 110 - 63.3=46.7

88	x coordinate of top chassis pivot relative to bottom pivot
188	y coordinate of top chassis pivot relative to bottom pivot

345	distance from bottom balljoint to lower chassis pivot

0	initial camber(degrees)- used to calculate length of top link
0	initial droop(degrees) - used to calculate length of top link

These dimensions are for calculating driveshaft length for IRS

20	x coord of diff joint or rack inner joint relative to bottom pivot
36	y coord of diff joint or rack inner joint relative to bottom pivot

83	distance from centre of tyre to centre of track rod end


This is the range of the suspension travel for the animation

-5	top of suspension travel (degrees)
5	Bottom of suspension travel (degrees)

These are just scaling factors
.5	scale to fit display - larger numbers increase the size of the animation
200	movement speed - smaller numbers=slower